Error 733

Error 733:  the PPP control protocol for this network protocol is not available on the server.

Resolution:
1) Ensure that the TCP/IP protocol is installed on your RAS server and that the TCP/IP protocol is selected in the Server Settings of the Network Configuration option of the Remote Access Setup dialog.
2) If you have the "Use DHCP to assign remote TCP/IP client addresses" option selected for the TCP/IP protocol in the RAS Server Settings, then ensure that you have installed DHCP and that it is not disabled.
3) Ensure that all of the bindings for TCP/IP are enabled in the Bindings tab of the Network dialog of the Control Panel. Be sure to inspect the TCP/IP Protocol and WINS Client (TCP/IP) bindings for all adapters, all protocols, and all services. If the TCP/IP bindings are corrupt, you may have to reinstall TCP/IP and or RAS in order to clean up the bindings.

  • 1 Kunder som kunne bruge dette svar
Hjalp dette svar dig?

Relaterede artikler

Error 619

Error 619: 1. The port was disconnected (or  Error 645, Dial-Up Networking could not complete the...

Error 628

Error 628:  The port is disconnected or The connection was terminated by the remote computer...

Error 768

Error 768 - The connection attempt failed because of failure to encrypt dataCause: the VPN server...

Error 734

Error 734 - The PPP link control protocol terminated.Resolutions: 1. this is most like security...

Error 783

Error 783 - Can't enable ICSSymptom: When you try to enable ICS, you may receive the following...