Error 913

Error 913:  A Remote Access Client attempted to connect over a port that was reserved for Routers only (also re:  Error 629  and 645). The event viewer may also generate the following event:
Event ID: 20188
Source: RemoteAccess
Description: The user username, attempting to connect on port, was disconnected because of the following reason:
A Remote Access Client attempted to connect over a port that was reserved for Routers only.

Resolutions:
1) Enable Remote access connections. To do this, go to Routing and Remote Access administrative tool>Ports>Properties, click the appropriate port (L2TP, Modem, PPTP, LPT1, and so on), and then click Configure, and then check the Remote access connections (inbound only).
2) Double-click the "Incoming Connections" icon on network connections folder and make sure "Allow VPN Connections" is enabled.

  • 8 Users Found This Useful
Was this answer helpful?

Related Articles

Error 649

Error 649.  The account does not have permission to dial-in.Resolution:1) This error can occur if...

Error 711

Error 711:  When attempting to start the Routing and Remote Access Service, you may receive "The...

Error 792

Error 792 -   The L2TP Connection Attempt failed because security negotiation timed out.Causes:...

Error 619

Error 619: 1. The port was disconnected (or  Error 645, Dial-Up Networking could not complete the...

Error 797

Error 797 -  The modem could not be found.Resolutions:1. Rebooting the machine that may solve the...