Error 619

Error 619: 1. The port was disconnected (or  Error 645, Dial-Up Networking could not complete the connection to the server and  Error 930, The authentication server did not respond to authentication requests in a timely fashion. The Event Viewer shows: Event id: 20073, Description: The following error occurred in the Point to Point Protocol module on port: port number, UserName:  user name. The authentication server did not respond to authentication requests in a timely fashion). When using VPN to access a remote network, W2K clients mat get above errors but not win9x and ME clients. This issue occurs because the VPN server hasn't registered in Active Directory.
2.You get this message when connecting via cable modems, dial up DOESN'T have any issues.

This error is most frequent on networks where PPTP is blocked. Select an L2TP server to connect. Please note that Windows XP might give error 789 with L2TP. Please see the solution In Error 789.

Resolution: 1) This problem most likely is secure issue such as unsecured password. So, check the settings.
2) It could be the hardware issue. Try to re-setup the device or download the new driver or just reset the devices such as modem and router.
3) Reapply the service pack
4) If the RRAS is in a domain network, add the VPN to the appropriate group. To do this, go to Active Directory Users and Computers>domain name>Users, double-click the RAS and IAS Servers security group. Select the members and add the VPN server to this group. 2) Type netsh ras add registeredserver at a command prompt (registeredserver is vpn server name), and then press ENTER.
5) If the router is connectijg to a modem and setup DHCP to receive IP from the modem, you may try to assign static IP to the WAN port on the router.

  • 4 Users Found This Useful
Was this answer helpful?

Related Articles

Error 734

Error 734 - The PPP link control protocol terminated.Resolutions: 1. this is most like security...

Error 800

Error 800: Unable to establish the VPN connection. The VPN server may be un-reachable, or...

Error 735

Error 735 - The requested address was rejected by server.Make sure you don't setup static IP on...

Error 630

Error 630 - The port was disconnected due to hardware failure1. Check that the modem is...

Error 711

Error 711:  When attempting to start the Routing and Remote Access Service, you may receive "The...